DRE offers a complete line of new or refurbished electrosurgical units from industry-leading brands.  Refurbished units are serviced and repaired to original manufacturers specifications by our trained biomedical technicians. Have a question? Our trained experts can help you decide which electrosurgical unit best fits your needs. Contact DRE at (800) 462-8195 .

Also known as Electrosurgical Generators, these devices come with a range of output levels and feature sets and are designed for different classes of surgical and anesthetic procedures.

Popular Brands

  • Valleylab
  • Conmed
  • Erbe
  • Bovie
  • DRE

Types of Units / Equipment

  • Desiccators / Hyfrecator - Aid in the performance of simple skin procedures
  • Grounded Electrosurgical Unit - Older style units that are considered outdated.
  • Isolated Power Electrosurgical Unit - Greatly improved over ground-referenced.  Uses pads to return electrical current to the unit.
  • Argon Beam Electrosurgical Unit - Use of gas in conjunction with electricity.
  • Smoke Evacuators - Electrosurgery typically creates smoke from procedures which can contact toxic gases and even living biohazardous material.  Smoke evacuators help greatly reduce the issues related to surgical smoke.

Operation Modes

  • Monopolar Output - Current flows from the surgical site back through the return electrode.
  • Bipolar Output - Lower power mode for delicate procedures.  No return electrode is used and instruments hook to a separate plug.  Not all electrosurgical units have this feature.
  • Pure Cut - Units that have this setting allow for clean deep cuts with limited tissue damage.
  • Blend - Pulsed bursts of coagulation to cut and seal at the same time to reduce bleeding.  Some units have a variety of Blend modes.
  • Coag ( Coagulation ) - Full coagulation for thermal charring to reduce or stop bleeding.  Coag options may include Pin-Point or Spray options to target exact / limited areas for coagulation.
  • Tissue Effects - More recent feature for higher end units that allows for more customization of the tissue response.
  • Cut - Cuts tissue cleanly with deeper and wider cuts based on increased power.
  • Desiccate - A form of low power coagulation that it drives moisture out of the tissue to eliminate targeted areas that are in contact with the electrode.
  • Fulgurate - Another form of coagulation where the electrode is not in direct contact with the patient but rather uses electrical arching to char the tissue to quickly stop bleeding.
  • Power - Needed power will depend on tissue impedance / resistance.  Different procedures will require different power levels.  You should only use the amount of power necessary for the type of procedure being performed.  Most modern generators have a variety of methods for adjusting power either automatically or manually.